CyberRota Analysis
AI-GeneratedThe vulnerability affects the Linux kernel's handling of the NXP LPC32xx UART, where a stuck RX character-timeout interrupt can lead to an interrupt storm that livelocks the CPU on single-core ARM926 systems. This issue arises when the RX FIFO is empty, causing the system to continuously trigger interrupts without clearing the timeout condition, ultimately impacting system stability. Organizations utilizing the NXP LPC32xx UART in their Linux environments should prioritize addressing this vulnerability to prevent potential system hang-ups and performance degradation.
Original NVD Description
In the Linux kernel, the following vulnerability has been resolved: serial: 8250_of: clear stuck empty-FIFO RX-timeout on LPC32xx The NXP LPC32xx UART (PORT_LPC3220) can latch an RX character-timeout interrupt while the RX FIFO is empty: IIR reports UART_IIR_RX_TIMEOUT (0x0c) but LSR.DR is clear. A character timeout is only cleared by reading RHR, but serial8250_rx_chars() reads RHR only when LSR.DR is set, so nothing ever clears the condition. The interrupt is level-triggered and re-fires immediately, so on a single-core ARM926 the resulting interrupt storm livelocks the CPU. It is reproducible when userspace repeatedly opens the front-panel port (ttyS1): serial8250_do_set_termios() re-enables interrupts on unlock and the handler then spins forever with iir=0xcc lsr=0x60 ier=0x05, tripping the soft-lockup detector in serial8250_handle_irq_locked(). LPC32xx has no dedicated 8250 glue driver, it's driven by the generic 8250_of. Add a hardware specific handle_irq for PORT_LPC3220, wired up in of_platform_serial_setup() the same way fsl8250_handle_irq is installed. The handler follows dw8250_handle_irq(): on an RX timeout with an empty FIFO (LSR.DR and LSR.BI clear) it does one throwaway RHR read to clear the condition, then calls serial8250_handle_irq_locked(). No real received data is ever discarded, and it is a no-op on healthy UARTs which never report a timeout with DR clear. This is the same class of bug already worked around in other 8250 drivers; see commit 424d79183af0 ("serial: 8250_dw: Avoid "too much work" from bogus rx timeout interrupt") which reports the identical iir=0xcc/lsr=0x60. See also UART_RX_TIMEOUT_QUIRK in 8250_omap, and the note in 8250_bcm7271.