CyberRota Analysis
AI-GeneratedThe vulnerability affects the Linux kernel's SPI (Serial Peripheral Interface) driver for i.MX8MP boards, where a failure to prepare DMA descriptors can lead to corrupted data during PIO (Programmed Input/Output) transfers. Specifically, when DMA cannot be initiated, the driver incorrectly retains DMA configurations, resulting in erroneous data being transmitted, particularly impacting devices like the Infineon SLB9670 TPM. Organizations utilizing affected Linux systems on i.MX8MP hardware should prioritize addressing this vulnerability to prevent potential data integrity issues.
Original NVD Description
In the Linux kernel, the following vulnerability has been resolved: spi: imx: reconfigure for PIO when DMA cannot be started When spi_imx_can_dma() selects DMA, the ECSPI is configured for DMA: spi_imx_setupxfer() sets CTRL.SMC and clears dynamic_burst, and spi_imx_dma_transfer() programs the dynamic-burst BURST_LENGTH and the SDMA watermarks. If the DMA descriptor cannot be prepared (dmaengine_prep_slave_single() returns NULL), the transfer is failed with SPI_TRANS_FAIL_NO_START and falls back to PIO. The dynamic-burst DMA path uses its own bounce buffers instead of the SPI core's mapping, so xfer->{tx,rx}_sg_mapped are not set and the core's DMA->PIO retry is skipped; the driver falls back to PIO internally. But none of the DMA-mode configuration is undone, so the PIO transfer runs with CTRL.SMC set, the wrong burst length and dynamic_burst cleared, and the transferred data is corrupted. This is easily hit on i.MX8MP boards that describe ECSPI DMA in the device tree but run SDMA on ROM firmware (no external sdma-imx7d.bin): every ECSPI DMA prepare fails. An Infineon SLB9670 TPM on ECSPI1 then returns shifted TPM2_GetCapability data, is flagged "field failure mode", /dev/tpmrm0 is never created. Set controller->fallback before re-running spi_imx_setupxfer() so the ECSPI is reconfigured exactly like a normal PIO transfer. With controller->fallback set, spi_imx_setupxfer() sees spi_imx_can_dma() return false, so it clears spi_imx->usedma and reprograms the controller (clears CTRL.SMC, restores dynamic_burst and the PIO burst length). No explicit spi_imx->usedma = false is needed: setupxfer() already updates it from the can_dma() result.